Maxwell Render • View topic - Protected Geomtry

View unanswered posts | View active topics

Board index » Plugins Support » Maxwell for Archicad » for MW 1.x

All times are UTC + 1 hour [ DST ]

Protected Geomtry

Page 1 of 1

[ 3 posts ]

Print view

Previous topic | Next topic

Author

Message

Daniel Hruby

Post subject: Protected Geomtry

Posted: Fri May 25, 2007 3:55 pm

Joined: Tue Aug 16, 2005 6:33 am
Posts: 471
Location: Oakland, CA

Is there anyway to have an option to "Unprotect Geometry" for further export from Studio? Right now any attempt to export a model for studio in OBJ format says it can not proceed as the geometry is protected.

_________________
Daniel Hruby
AIA | LEED AP
http://www.visualizeitbuilt.com

OSX 10.6.7 Snow Leopard
MacPro 3.0 GHz 8 Core 12GB
ArchiCAD 14 • Modo 501 • Terragen 2.3

Top

pelias

Post subject:

Posted: Thu May 31, 2007 2:08 pm

Joined: Mon Apr 18, 2005 2:32 pm
Posts: 361

As far as I know such option is not available - I will ask Studio developers though to confirm that.

Pavol

_________________
Pavol Elias
Next Limit Team

Top

pelias

Post subject:

Posted: Thu May 31, 2007 2:44 pm

Joined: Mon Apr 18, 2005 2:32 pm
Posts: 361

OK - I was wrong :-)

All the exported geometry is protected by default but there is an option in Maxwell SDK to disable the protection. However this is not supported by ArchiCAD plugin at the moment - I will add it to the next version of the plugin.

Pavol

_________________
Pavol Elias
Next Limit Team

Top

Page 1 of 1

[ 3 posts ]

Board index » Plugins Support » Maxwell for Archicad » for MW 1.x

All times are UTC + 1 hour [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: